SS Set steps. Preset number of steps into memory

Command	Command description	Controller response	Default mode (N/A - not available)	Service Mode (N/A - not available)
xSSy	Preset number of steps into memory. Y sign sets the motion direction. 1 micro step = 1/8 of motor step. Consider ST command.	-	Yes	Yes

SYNTAX    xSSy
Where x – controller (axis) number
PARAMETER y [number] sets number of micro steps to be moved. 1 micro step = 1/8 of motor step. The sign sets the direction of rotation.
Range    -2000000000...2000000000.
DESCRIPTION: This command does not initiate any motion. When command is received, the number of y micro steps is saved into memory for future use. Sequential ST command uses the parameter. Preset number of steps can be tested (read) by xGP1 command.
Note: SS and ST commands are defined to initiate synchronous motion of several axis. For this case ST employ exceptional 0 axis number (controller address), which effects all cascaded controllers on the chain.
RETURNS  none
REL. COMMANDS SH, ST, MV
EXAMPLES: 5SS200000    ||     3Ss -78000  ||   431 ss 16